Latest Danfoss VFD Parameters

By request here are my latest parameters that are changed from default...  

ID Name Setup 1 Unit (Notes)

009 Display line 2 Output energy [kWh] 

010 Display line 1.1 Dc link voltage [V] 

011 Display line 1.2 Reference [%] 

012 Display line 1.3 Torque [%] 

014 Local stop Disable 

102 Motor power 15.00 kW 

103 Motor voltage 415 V 

105 Motor current 28.00 A 

106 Motor nom. speed 1450 RPM 

108 Stator resist 0.2722 Ohm 

109 Stator react. 20.47 Ohm 

113 Lo spd load comp 150 % (For hill starts) 

114 Hi spd load comp 100 % 

115 Slip compensat. -300 % (Gives better throttle response at high speed) 

119 High start torq. 0.5 s 

128 Mot.therm protec Etr warning1 

129 Motor extern fan Yes

200 Out freq rng/rot 132 hz both direct. 

202 Out freq hi lim 132.0 Hz 

205 Max. reference 132.000 

206 Ramp type S2 

207 Ramp up time 1 6.00 s (Economy) 

208 Ramp down time 1 1.00 s 

209 Ramp up time 2 2.00 s (Power) 

210 Ramp down time 2 1.00 s 

221 Torq limit motor 348.5 % 

222 Torq limit gener 60.0 % 

224 Warn. current hi 97.6 A 

227 Warn. feedb. low -4,200.000 

228 Warn. feedb high 4,200.000 

300 Digital input 16 No operation 

301 Digital input 17 No operation 

302 Digital input 18 Latched start 

305 Digital input 29 Ramp 2 

306 Digital input 32 No operation 

307 Digital input 33 Encoder fb, input a 

314 Ai [mA] 60 funct No operation 

319 Ao 42 function Fb min-max =0-32000p (Speedo) 

320 Ao 42 puls scale 66 Hz 

321 Ao 45 function 0-tlim = 0-32000p (Tacho) 

322 Ao 45 puls scale 99 Hz 

323 Relay 1-3 funct. No operation 

326 Relay 4-5 funct. No operation 

329 Encoder pulses 40 (Inductive pickup gear) 

405 Reset mode Automatic x 2 

410 Inv.fault delay 35 s 

411 Switch frequency 3.0 kHz 

415 Max. feedback 4,500.000 

416 Ref/feedb. unit Rpm 

417 Speed prop gain 0.015 

445 Flying start Enable 

446 Switch pattern 60° avm 

457 Mains imbalance Warning