(Power is 10x.) The above data was captured from the Danfoss VFD.
This would indicate that the Dyno run yesterday did not reach peak power / torque.50km/hr = 2100 RPM. The motor torque from the dyno plot at 50km/hr would be 2100*.323/5.125=132Nm. This (very roughly) corresponds to the scatter plot at that RPM.
The dyno plot can be for all intents ignored unfortunately. I will go and see them and see if they can do plots at multiple single speeds.
1 comment:
Hi Mal,
Your scatter chart shows a flat top or constant power output above a certain RPM and torque rolling off after a certain RPM. This is what one would expect to see.
I would question the dyno graph too!
Bill in Oregon
Post a Comment