Tuesday, 2 September 2008

Engine Mount and Driveshaft installed.

This is the view looking up from under the vehicle.
The aluminium block holds the inductive pick-up. (Thanks Geoff)
The drive flange is the grey part.
The Universal and sliding spline are bolted to the drive flange.

I spent ages looking for 10mm x 1mm pitch bolts. I should have gone to Toyota first. They were just a couple of dollars each!



This is the rear mount that attaches to where the gearbox used to attach.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.