Thursday, 29 May 2008

Update - Batteries - Tester - Diff - Steering - VFD - Tray

It has been a few weeks since my last post so an update is in order. photos to follow.

1. I received the Greensaver batteries (20ah and 27ah - 2 hr rate). The port chargers were unbelievable! These would have to be the 2 most expensive batteries in Australia! Lesson learned about sea-freighting goods

2. I have built a micro controller based charger / discharger. It will measureand log to a PC the following aprameters during discharge and charge Volts, Amps, Watts, Ah, Wh, temperature and the all important Peukert factor. It uses 4 x 1 ohm resistors. The resistors can be wired differently to vary the test current. I am waiting an LCD from Futurelec and a charger from ebay's ecrazyman.

3. I have bought a diff from pick'n'payless . It is a 5.125 ratio from a Hiace van. All going well I will install it this weekend. This gives a theoretical top speed of 94km/hr at 4000RPM

4. I also bought a manual steering box from pick'n'payless for installing this weekend.

5. Better VFD. I bought a better Danfoss 5042 VFD off ebay. So, if anyone wants a Danfoss 6042VFD in an IP54 case I have one looking for a home. I have removed all the AC components from the cabinet to minimise losses and will feed it DC directly to the soft charge circuit.

6. The ute has a tray back which was way too wide for the body. To tidy up the looks I have narrowed the tray to be the same as the body (100mm off each side) and shortened the back. If I need sides I can get them from the manufacturer which is encouraging.

At the moment the carport looks like a car wreckers yard, but things should start coming together in the next few weeks. I am still waiting to borrow an engine hoist from my neighbours.

No comments:

Post a Comment

Note: only a member of this blog may post a comment.